GE AT600 - Page 142

Chapter 5. Communication
130 AT600 User’s Manual
Command 206 (0xCE): Write Fluid Information (cont.)
Command 208 (0xD0): Read Calibration Configuration
This command is to read Calibration Configuration.
Table 134: Command-Specific Response Codes
Code Class Description
0 Success No Command-Specific Errors
1 Undefined
2 Error Invalid Selection
3-4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7Error In Write Protect Mode
8-15 Undefined
16 Error Access Restricted
17-127 Undefined
Table 135: Request Data Bytes for Read Calibration Configuration
Byte Format Description
None
Table 136: Response Data Bytes for Read Calibration Configuration
Byte Format Description
0 Unsigned-8 Reynolds correction
1 Unsigned-8 Active MultiK Enable
2 Unsigned-8 KFactor Type:
0: Velocity, 1: Reynolds
3 – 6 Float Static KFactor
7 Unsigned-8 KFactor Points
8 - 11 Float Kinematic Viscosity