Chapter A4: Image Acquisition
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A4-3
Operator Manual © 2008 General Electric Company. All rights reserved.
exam If multiple exams were selected from the Worklist, switches
between exams for protocol selection, technique adjustment, and
acquisition.
This drop-down list does not appear if a single exam was selected,
or if the exam was initiated with the Emergency Exam or Cassette
Exam buttons on the Worklist.
protocol list Lists the available views for the exam and shows which view is
currently active.
[SELECT PROTOCOLS] Brings up the Select Protocols screen to add, remove, or change
protocols.
Refer to Select or Change Protocols
(p. A4-7) for more information.
[SUSPEND] Ends the exam with the intent of continuing at a later time. Does
not initiate auto send or auto print, if enabled.
Refer to End Exam
(p. A4-13) for more information.
[CLOSE] Closes the procedure. If enabled, [CLOSE] sends billing information
to the PACS system, auto sends, and auto prints acquired images.
Refer to End Exam
(p. A4-13) for more information.
[DISCONTINUE] Ends the exam when the procedure has been opened but the
exam cannot continue.
Refer to End Exam
(p. A4-13) for more information.
Function Description
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
