GE Definium AMX 700 - Page 11

Revision History
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) iii
Operator Manual © 2008 General Electric Company. All rights reserved.
Revision History
Rev
#
Date
Pages
Affected
Reason for Change
1 09 Dec. 2005 All Initial release.
2 27 Mar. 2006 1-1 Updated description of unit.
2-5 Inserted warning about inserting fingers into the Ethernet port.
3-2 Added cross-references in table 3-1.
Added wireless antenna information in table 3-1.
3-3 Added cross-references in table 3-1.
3-4 Added notes and information about the detector bin in table 3-1.
3-5 Inserted warning about inserting fingers into the Ethernet port in table 3-1.
5-3 Procedure re-written (all text before figure 5-2).
6-3 Battery drain percentages revised, figure 6-2 replaced.
6-4 Removed note before “Bar Graph Display vs. Battery Loading” section
Updated Approximate Discharge Rate and Typical Daily Usage numbers in table
6-2.
6-5 Figure 6-3 replaced.
6-6 Added 2 “IMPORTANT!” notes after step 5.
6-7 Moved “Main Power Circuit Breaker” information from the Maintenance and
Service chapter.
Figure 6-5 replaced.
7-1 Switched order of “Maintenance” and “Messages” chapters.
7-2 Updated descriptions of “Battery Too Low” and “Charge Required” messages in
table 7-1.
8-1 Updated approved cleaning chemical list.
A1-5 Added weight in kilograms caution in Figure A1-3.
A1-6 Updated table A1-2, detector status lights.
A1-7 updated list “Do not do”.
A1-8 Updated external ambient temperature range in table A1-3.
A1-10 Removed references to the grid holder.
A1-11 Added grid handling instructions.
A2-3 Added start up instructions.
A2-7/8 Added wireless network connection section.
A2-9 Added step to system reset procedure (step 3).
A2-11 Removed paragraph before figure A2-10.
A3-6 Added “network connection status” and “wireless network connection status”
rows to table A3-1.
A3-8 Corrected description of Accession number in table A3-2.
A3-9 Corrected first bullet below step 3.
A3-20 Corrected description of Accession number in table A3-4.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).