Revision History
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) v
Operator Manual © 2008 General Electric Company. All rights reserved.
3 (continued) 8-2 Changed row in table 8-1, “SLOW CHARGING” to “STANDBY” and updated
description of message.
A2-2 Replaced figure A2-1.
A2-4 Added cross-references to “Software Reset” section.
A2-8 Added new procedure for switching between wired and wireless connections.
A2-8 Added note that software reset does not require shut down or reset.
A6-12 Removed that CD-RW disks may be used to copy exams, added note that the
system cannot write to CD-RW disks.
A6-13 Added new step 8 to confirm that images have been written to the CD.
A7-1 Re-wrote chapter introduction.
A7-14 -- 15 Added notes in table A7-6, in the “Plus Previous” and “Plus Future” rows.
A7-26 Changed text in table A7-9, clarified what happens to images without the Auto
Tag mark upon auto delete.
A7-31 Added new descriptions of DEI displays to the options listed after step 2.
A7-32 Changed description of Technical Mode.
A7-33 -- 40 Re ordered the Image Processing sections, updated information to match current
system.
A7-44 Removed that CD-RW disks may be used to copy protocol database, added note
that the system cannot write to CD-RW disks.
A7-50 Removed “Unpaired” as an option for Laterality.
B-13 Changed text in table B-1, row Inactivity Timeout. Added that this function is not
implemented and that changing the settings may cause conflicts with system
software. Removed most of the description.
4 29 Sep. 2006 All Miscellaneous typographical and grammatical corrections.
3-4 Deleted information from table 3-1, row 15, regarding opening and closing the
detector bin. Unit design has changed so that it is always open.
4-4 Deleted information from step 3 regarding closing the detector bin.
4-7 Inserted note regarding that the tether should be removed from the column
holder before rotating the column.
7-1 Added cross-reference to Chapter A1: Detector Overview-Handling and Cleaning.
A1-1 -- 13 Re-ordered chapter to better suit end-user needs.
A1-2 Corrected information in “Detector Functions” section.
A1-3 Corrected information in “Panel” section.
Corrected information in “Electronics” section.
Corrected information in “Physical Appearance / Finish” section.
A1-4 Corrected information in “Nameplates and Markings” section.
Corrected information in “Detector Alignment” section.
A1-5 Updated information in table A1-1.
A1-6 Added section on “Electro-magnetic Interference”.
Rev
#
Date
Pages
Affected
Reason for Change
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
