GE Giraffe Service Manual

4.4.28 System Failure 35
System failure 35 indicates: Wrong dipswitch set up.
Cause(s) Action(s)
Switches set wrong
Check the 8 position dipswitch on the control board. Verify that Switch 1 is on
and Switch 2 is o.
Defective control board. Replace control board.
4.4.29 System Failure 50
System failure 50 indicates: Incorrect display driver board System Software checksum.
Cause(s) Action(s)
Defective System Software PROM on display driver
board.
Install new system software 6600-0234-850.
Defective display driver board.
If the system failure persists, replace display driver
board.
4.4.30 System Failure 51
System failure 51 indicates: Display Defective SRAM.
Cause(s) Action(s)
Defective SRAM circuit on the display driver board Replace the display driver board.
4.4.31 System Failure 52
System failure 52 indicates: Display No Timer2.
Cause(s) Action(s)
Defective display driver board. Replace the display driver board.
4.4.32 System Failure 53
System failure 53 indicates: Display Timer2 Too Fast.
Cause(s) Action(s)
Defective display driver board. Replace the display driver board.
48 6600-0356-000 103 © 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 4: Troubleshooting

GE Giraffe Specifications

General

Manufacturer	GE Healthcare
Type	Incubator
Humidity Range	30% to 95% RH
Power Supply	50/60 Hz
Model	Giraffe
Features	integrated scale
Control Modes	Air and Skin