Section 9 — Working with Routes
172
7. Press to start recording — When the first location's recordings
are complete, the Route menu displays again with the next location
highlighted. A percentage % symbol indicates how many of the
previous location's route entries were recorded.
NOTE: Depending on your configuration in Ascent, you may be
asked for a machine speed value while collecting routes. The
Machine RPM box will display if the machine is RPM-based. If the
machine is linear speed, the Linear Speed box will display. Enter
the machine speed manually before continuing, or aim the laser
tachometer at the reflective tape on the shaft to acquire the speed
automatically.
NOTE: Speed multiplier configured in Ascent will be applied
automatically to all measurements. However, the following
exceptions apply for RPM-based machines — The multiplier value
will be ignored if the measurement is tachometer-triggered. For
linear speed machines, the multiplier will be ignored if a physical
tachometer is configured.
8. Press again to start the next measurement — Continue to take
recordings until all route entries have been recorded.
Taking recordings using a route
To Next Page
Loading...
