GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 7 Diagnostics/Troubleshooting 7-87
7-4-9 Checking the Network Adaptors from Windows Device Manager
NOTE: This check is performed on the system while in Technical Support Mode, as described below. Make
sure the T-plug (dongle) is inserted into the parallel port on the rear panel.
1) Turn ON the system by pressing the ON/OFF button on the control console and re-boot into
Technical Support Mode using the T-plug.
While re-booting the system, be prepared to select Technical Support Mode when prompted, then
press <Enter>.
2.) From the Windows desktop, select Start > Programs >Computer Management > Device
Manager > Network Adaptors, as shown below.
Figure 7-58 Checking the Network Adaptors
3.) Make sure that the Intel(R) PRO/100VE Network Connection is indicated as shown in
Figure 7-58, above.
To Next Page
Loading...
