GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 8 Replacement Procedures 8-59
8-5-1-4 Back End Processor Installation Procedure (cont’d)
6.) Connect the keyboard cable to the keyboard socket [5].
7.) Connect the cable to the COM 1 socket [6].
8.) Connect the cable to the HASP and Parallel OUT socket [7].
9.) If available on the system, connect the USB cable to the USB socket [8].
10.) If available on the system, connect the Network cable to the Network socket [9].
11.) Connect the Back End Audio BKT EXT cable to the Audio IN/OUT socket [10b].
12.) Connect the Back End Audio BKT EXT cable to the Audio IN/OUT socket [10a].
13.) Connect the PC2IP cable to the PC2IP IN/OUT socket [11].
14.) If available on the system, connect the modem communication cable to the COM 3 and 4 socket
[12].
15.) Connect the Back End KB Cont P1 cable to the Ext Keyboard socket [13b].
16.) Connect the Back End KB Cont P2 cable to the Ext Keyboard socket [13a].
17.) Connect the VIC/ Rear Panel left connector cable to the RGB Video OUT
socket [14].
18.) Connect the Keyboard/VIC External power cable to the power to Keyboard Matrix socket [15].
Note: IMPORTANT - Do NOT connect the HASP key to this socket! - refer to step 8 above
[connection to socket 7].
Figure 8-55 Cable Connections on BEP2 Rear Panel
X
COM1
X
HASP and Parallel OUT
USB
Network
Audio IN/OUT
PC2IP IN/OUT
Ext. Keyboard
COM3 & 4 for Modem
(only if option installed)
VGA OUT (to Monitor)
Power to Keyboard Matrix
RGB Video OUT
Plug & Scan, optional
BEP Power
1
3
4
2
6
5
7
8
9
12
11
10a
10b
VIC VGA OUT
VIC VGA IN
Trackball
Keyboard
Do not use
Do not use
Audio IN/OUT
13a
13b
16b
16a
14
15
To Next Page
Loading...
