GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
8-88 Section 8-5 - Back End Parts Replacement
8-5-13-4 PC-VIC Installation Procedure
1) Place a new PC-VIC in the PC-VIC module holder.
2) Return and tighten the four screws (two each side) on the side of the holder - refer to
Figure 8-75 "PC-VIC Removal" on page 8-87.
3.) Reconnect all the cables at the rear of the PC-VIC module and the hard disk.
4.) Carefully slide the PC-VIC into position in the same location as that of the removed PC-VIC.
5.) Return and tighten the screw that holds the PC-VIC in position (as shown in Figure 8-74 "PC-VIC" on
page 8-87).
6) Replace the BEP side cover as described in 8-5-3-4 "BEP2 - Side Cover Installation Procedure" on
page 8-64.
7) Remove the Vivid 3N left cover, as described in 8-2-2-4 "Side Covers Installation Procedure" on
page 8-4.
To Next Page
Loading...
