GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 8 Replacement Procedures 8-139
8-8-4-5 Color Video Printer Removal - Procedure 1
NOTE: This procedure (Procedure 1) is for units that are equipped with a previously-installed B&W printer and
a VCR. The color printer option includes a metal shelf and fastening belt on which the color printer is
placed.
1) Unlock the belt buckles located on either side of the color printer.
Figure 8-123 Belt Buckles Securing Printer
2) Move the color printer forwards, to gain access to the rear panel.
3) Open the lower middle screw from the color printer’s rear panel and remove the Ground cable lug.
4) Unplug the AC cable.
5) Unplug the BNC connectors R-G-B and SYNC from the color printer.
6) Remove the color printer from the top shelf.
Note: Perform the following steps only if the metal shelf must be removed.
7) Remove the right and left screws located in the legs on either side of the shelf, and remove the shelf.
Note: Do not perform the following step if the metal shelf will later be replaced.
8) Return and fasten the two screws (removed in step 7) to either side of the top cover.
Belt Buckle
To Next Page
Loading...
