GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 3 - System setup 3 - 41
Section 3-10
Connectivity setup
NOTE: If connected to a stand-alone network (Peer-to-Peer network with a VIVID E9 scanner, an
EchoPAC PC workstation and an optional network printer), you should use default delivery
settings.
3-10-1 Introduction
To be able to use the network functions when connected to a hospital network, the scanner must have
a proper network address.
• Before you can set up the scanner, you need to collect some information.
•The "Worksheet for DICOM Network Information" on page 2-13 can be used for gathering this
information.
• Typical source for this information is the network administrator.
3-10-2 Compatibility
VIVID E9 can communicate with:
• EchoPAC PC
• Image Vault
• Other units via DICOM