GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 10 - Care & maintenance 10 - 3
Section 10-3
Maintenance task schedule
10-3-1 How often should maintenance tasks be performed?
The Care and Maintenance task schedule (provided on page 10-3) specifies how often your VIVID E9
should be serviced and outlines items requiring special attention.
NOTE: It is the customer’s responsibility to ensure the VIVID E9 care & maintenance is performed as
scheduled in order to retain its high level of safety, dependability and performance.
Your GE Service Representative has an in-depth knowledge of your VIVID E9 ultrasound scanning
system and can best provide competent, efficient service. Contact GE for coverage information and/or
price for service.
The service procedures and recommended intervals shown in the Care and Maintenance Task
Schedule assumes that you use your VIVID E9 for an average patient load (10-12 per day) and not use
it as a primary mobile unit which is transported between diagnostic facilities.
NOTE: If conditions exist which exceed typical usage and patient load, then it is recommended to
increase the periodic maintenance frequencies.
.
Table 10-1 Customer Care Schedule sheet 1 of 2
Service at Indicated Time Daily Weekly Monthly
Per
Facilities
QA
Program
Notes
Clean Probes •* * or before each use
Clean Probe Holders
•
Clean Air Filters •
more frequently depending on
your environment
Clean Console •
Inspect AC Mains Cable • Mobile Unit Check Weekly
Inspect Cables and Connectors •
Clean Monitor and Touch Panel •
Inspect Wheels, Casters, brakes and
Swivel Locks
• Mobile Unit Check Daily
Check Operator Panel Movement
• Mobile Unit Check Daily
Console Leakage Current Checks •
also after corrective
maintenance
Peripheral Leakage Current Checks •
also after corrective
maintenance
Surface Probe Leakage Current Checks •
also after corrective
maintenance
Endocavity Probe Leakage Current
Checks
•
also after corrective
maintenance