GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 8 - Replacement procedures 8 - 281
8-11-8 SATA Jumper replacement
The SATA Jumper connects CN DV11 to CN DV12 in 2D systems wilhout DVR.
The jumper is included in the BEP6.X Cable Kit - Spare Part, Part number 5433408-80.
8-11-8-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.)
8-11-8-2 SATA Jumper removal
Disconnect the SATA Jumper from the connectors CN DV11 and CN DV12 on the motherboard.
8-11-8-3 SATA Jumper installation
1.) Install the SATA Jumper in the connectors CN DV11 and CN DV12 on the motherboard.
2.) Install the BEP Cover.
3.) Install the Left Side Cover.