GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 280 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-7-4 BEP Power In Cable installation
Follow these steps to install the BEP Power In Cable:
1.) Connect the new BEP Power In Cable to PCN 2 on the BEP6 Power Board.
2.) Install the J1 connector in the frame with the two screws (from below) and the nuts (above).
3.) Install the HDD Bracket. Ensure that the BEP Power In Cable is routed above the HDD Bracket
before you fix it to the frame with the four Phillips screws from above.
4.) Install the HDD.
5.) Install the BEP in the VIVID E9.
6.) Install all the cables to the BEP.
7.) Install the BEP Cover.
8.) Install the B/W Printer.
9.) Install the VIVID E9 covers you removed earlier.