GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 19
8-4-10-5 Press A. Install System Software. (Erase all partititions)
Installing the System Software
1.) Press “A” to erase all the content on the HDD and install the System Software.
Next, you are asked to confirm that you will erase the whole disk.
2.) Press “Y” to confirm that you will continue. (If you want to return to the previous screen, press “N”)
Figure 8-8 Are you really sure? Delete HDD Content
This will erase the whole harddisk before installation!
Are you really sure? y/n :
This will erase the whole harddisk before installation!
Are you really sure? y/n : Y
Installing All . . .
This will erase the whole harddisk before installation!
Are you really sure? y/n : Y
Installing All . . .
Partition Status Type Volume Label Mbytes System Usage
C: 1 *DELETED*
YOU HAVE TWO CHOICES HERE.
EITHER PRESS ‘Y’, AND THE INSTALLATION WILL CONTINUE,
OR PRESS ‘N’, AND RETURN TO THE PREVIOUS SCREEN
WITHOUT DELETING OR INSTALLING ANYTHING.
‘Y’ WAS PRESSED, AND THE INSTALLATION STARTS.
THE EXISTING CONTENT ON THE HARDDRIVE
IS DELETED.
To Next Page
Loading...
