GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 8 - Replacement procedures 8 - 63
8-5-14-2 Column Cover Assembly removal
Follow these steps to remove the Column Cover Assembly:
1.) Lower the console to lowest possible level.
2.) Remove the lower screw on the right side that is visible near the rear of the DVD drive.
3.) Raise the console to full height.
4.) Remove the remaining screw on the right side that secures the Column Cover Assembly.
5.) Remove the 2 screws on the left side that secure the Column Cover Assembly.
6.) Remove Column Cover Assembly.
NOTE: The Main Cable Cover will also be released.
Figure 8-62 With console lowered, lower right side screw placement
Figure 8-63 With console raised, upper right side screw placement
Figure 8-64 With console raised, left side screw placement
DVD DRIVE
LOWER RIGHT
SCREW
MAIN CABLE
COVER