GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 8 - Replacement procedures 8 - 131
8-6-18-2 Encoder Board removal procedure
1.) Disconnect the cable to the Encoder Board.
2.) Turn the Operator Panel, Lower with the front up.
3.) Unscrew and remove 4 screws.
4.) Remove the Encoder Board.
8-6-18-3 Encoder Board installation procedure
1.) Position the Encoder board so the holes for the fixing screws aligns.
2.) Install the four screws.
3.) Turn the Operator Panel, Lower with the front down.
4.) Plug in the cable to the Operator Panel, Lower.
5.) Install the Operator Panel, Lower.
6.) Install the Operator Panel, Upper.
Figure 8-145 Fixing screws