GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 156 Section 8-6 - Top Console Parts Replacement
8-6-27-2 Remove the Speaker Assembly
Follow these steps to remove one of the Speaker Assemblies:
1.) Remove the hex key screw, fixing the Speaker Bracket to the OP frame.
2.) Disconnect the Speaker Cable from the Bulkhead board.
3.) Remove the Speaker.
4.) Repeat steps 1 - 3 for the other Speaker assembly, if necessary.
8-6-27-3 Install the Speaker Assembly
Follow these steps to install the Speakers:
1.) Position the Speaker.
2.) Install the hex key screw, fixing the Speaker Bracket to the OP frame.
NOTE: Check that the speaker bottom edge is tight or the speaker may rattle.
3.) Connect the Speaker Cable to the Bulkhead board.
4.) Repeat steps 1 - 3 for the other Speaker.
5.) Install the Operator Panel, Upper.
Figure 8-166 Speaker hex key screw
hex key screw BEHIND
RIGHT SPEAKER
To Next Page
Loading...
