GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 210 Section 8-9 - Casters and Brakes replacement
8-9-1-4 Rear Casters installation procedure
1.) Position the Caster so it align with the hole for the fixing bolt.
2.) Install the fixing bolt (M12 X 40 mm). Use a 10 mm HEX key, Torque: 130 Nm.
3.) Remove the Wooden Wedge.
4.) Roll the VIVID E9 off the Bevel Edged Board.
5.) To replace the other Rear Caster, repeat all the steps, starting from 8-9-1-3 "Rear Casters removal
procedure" on page 8-209, but now using the Bevel Edged board and the Wooden Wedge on the
other side of the VIVID E9.
6.) Install the Rear Cover.
7.) Install the Rear Bumper.
8.) Install the Side Covers.