GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 264 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-4-3 Preparations - BEP5/BEP6
When preparing for the removal, or replacement, of a Graphical Adapter, you must perform the following
steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.) Next;
- for BEP6, continue with:
8-11-4-4 "Removing the Graphics Adapter from the BEP6" on page 8-265.
- for BEP5, continue with:
8-11-4-8 "Removing the Graphics Adapter from the BEP5" on page 8-269.