GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 274 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-5-2 Front Module removal procedure
Follow these steps to remove the Front Module:
1.) Place the BEP on a table for better access (and ergonomics).
2.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
NOTE: BEP5: Remove the HDD to get better access.
Ref.: 8-11-3 "Hard Disk Drive (HDD) replacement" on page 8-256.
3.) BEP6 only: Remove the Graphics Adapter to get better access.
4.) BEP5: Disconnect the cables at the back of the Front Module.
BEP6: Disconnect the Front Module Cable from the motherboard.
NOTE: See 8-11-3 "Hard Disk Drive (HDD) replacement" on page 8-256 for more information.
5.) Remove the two screws securing the Front Module to the BEP frame.
6.) Remove the Front Module.
Figure 8-240 Front Module cable placement (BEP5 illustrated)
Figure 8-241 Front Module screw placement
FRONT MODULE CABLES
FROM INSIDE BEP
To Next Page
Loading...
