Getinge GE15 - Page 40

User right Users Access
K Password 1 Operator,
Supervisor,
Service
technicians
Acknowledge the
alarm.
L Password 2 Service
technicians
Controlled by Boolean
application such as
confirmation or start.
*The following parameter types are available:
• A parameters, adjustable parameters. Users with the rights to
adjust the process are allowed to edit these.
• P parameters, programmable parameters. These parameters
are displayed to the user with access to extend process
settings, but editing them is not allowed.
• I parameters, information parameters. These parameters are
displayed to all users but editing them is not allowed.
3.2.3.4.1.3 Change Password
To change the password:
1. To enter a new password, select and press .
2. An entry window is displayed. Enter the new password and
select and press . The previous window is displayed
again.
3. To confirm the new password, select and press .
4. An entry window is displayed. Enter the new password and
select and press . The previous window is displayed
again.
5. Select at the bottom of the list and press to save
changes.
3 MENU TREE
40 (128) TECHNICAL MANUAL GETINGE WD15 CLARO
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>