GPS TrackMaker - Editing Routes

Editing Routes
Editing General Parameters of the Routes
To display the parameters of all Routes, click on the Routes-General option located beside the table. The following
fields can be viewed:
• Route Name
• Number of Points
• Total length
• Start Waypoint
• End Waypoint
Only the Route Name can be changed. The others fields in yellow cells can be copied.
Editing Isolated Routes
First select the Routes-Detailed option located beside the table, and then choose the Route to be edited, clicking in
the available list. The following fields of each Route can be modified:
• Waypoint name with up to 10 characters
• Latitude
• Longitude
• Altitude of the Point
• Comments with up to 255 characters
• Icon of Waypoint
• Style of Waypoint
• Segment length
• Segment azimuth
Length and azimuth shown in blue cells can be changed, but affect the coordinates, length and azimuth of the
next segment.
Searching Addresses
if a street level map is loaded, it is possible to create complete reports with addresses where the GPS or vehicle
equipped with the tracking module passed.
Follow the steps below to create a detailed report:
● Choose the spreadsheet of Waypoints or Tracklog which the report will be created.
● Choose the maximum distance of search. As larger the distance, more time is required to search the
maps.
● Click on button or press F6 to start the addresses search.
Sorting the Table
To sort the table in ascending order, first click on the column cell to be sorted. Then, press to sort the whole
table in ascending order. To return the table to the initial sort order, just release again. The Table
arrangement can also be done through the Sort option in the Data menu.
76