(advising correct operation), the device will reboot itself automatically.
6) If keypad entry time out (not finish the input within 60 seconds), the device will exit this password reset
mode automatically and stop the backlight flashing. After successful password reset, operator will then be
able to log into the GDS37xx webUI with default password, all the configuration inside the device will be
the same and will NOT be changed.
For example:
Decoding the string into digits and write to paper before doing the operation:
• Device with last 6 MAC address: 33DDDD
• Decoding the last 6 MAC to digits would be: 334444
• Default password is: xwpxz6AA
• Decoding the default password to digits would be: 2423162426611
1) Enter ***334444**# via keypad, get into the password reset mode, the keypad backlight will flash quickly.
2) Within 60 seconds, enter 2423162426611#, the device will play one long beep then reboot itself.
3) Wait the device finishing boot up, log in the webUI using the default password, xwpxz6AA
To Next Page
Loading...
