• Added support for “Normal Open” or “Normal Close” setting when Alarm Out1 is set to Open Door.
[ALMOUT1 Status]
• Added support for System Health Alerts via Email. [System Health Alert]
• Added option to upload custom doorbell ringtone. [Enable Custom Doorbell Ringtone]
• Added option to set Schedule for “Local PIN to Open Door”. [Local PIN to Open Door Schedule]
• Added support for CSV format when Importing/Exporting Card user data. [Card Management]
• Added support for Anonymous Snapshot. [Enable Anonymous LiveView]
• Enhanced security by only allowing numbers existing under “White List” to open the door remotely
when call is initiated from GDS3710. [Remote PIN to Open the Door]
• Added Boot version information into System status. [Boot Version]
Firmware Version 1.0.5.2
• Added Alarm_Out port (COM1 interface) be used as Open Door 2. [Using Alarm Out (COM 1) to
Control a Second Door]
• Added option to Enable/Disable WebUI access. [Disable Web Access]
• Added option to define number of snapshots to be uploaded when opening door. [Number of
Snapshots when Door Opened]
• Added option to specify digital input to be normal Open or normal Close. [Input Digit 1 Status]
• Added ability to set schedule for Alarm In door opening. [Select Alarm Schedule]
• Added support for using Digit Only as Private PIN. [Local PIN Type]
• Added option to configure “No Key Entry Timeout”. [No Key Input Timeout]
• Added ability to email snapshot when door opened. [Snapshot when Door Opened]
• Added option to allow anonymous viewing. [Enable Anonymous LiveView]
• Added option to configure payload type for H.264. [H.264 Payload Type]
• Extended VLAN tag range from 0 to 4094. [Layer 2 QoS 802.1Q/VLAN Tag]
• Added option to use Emergency PIN to overwrite “Keep Door Open” schedule and lockdown.
[Emergency PIN]
• Added ability to configure device with custom certificate signed by custom CA certificate.
[Certificates]
• Added support for special character “@” in the SIP User ID. [SIP User ID]
• Added SIP NOTIFY to factory reset the GDS3710. [Allow Reset Via SIP NOTIFY] [Restore to
Factory Default Via SIP NOTIFY]
• Added event log showing the users (Username) opening door via private PIN. [Event Log]
Firmware Version 1.0.4.9
• Added support for Parallel Hunting when doorbell pressed [Door Bell Call Mode]
• Enhanced HTTP Event Notification details: Added “CARDID” and “SIPNUM” [URL Template]
• Add support for TLSv1.2
To Next Page
Loading...
