5-5
Supplement
It will return to default screen without scanning
when you press the [ESC] key (CANCELN).
9
Conrm the tool position and press the [ENTER] key.
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage faster.
10
Press the POSITION (
) keys to move the tip of the tool
to the alignment mark position.
Move the tool to the new origin point (Point you want to be the origin
point).
11
Conrm the setting and press the [ENTER] key (SET).
The tilt angle of the X axis is calculated and the axis alignment is
performed. On completing it, it will return to default screen.
To Next Page
Loading...
