7-19
7.6
Setting Initial Blade Control Position Adjust
After turning on the power or changing pen condition settings, touch the blade to the media and adjust the blade
direction. The Initial Blade Control Position will need to be set in order to make sure the area is not damaged and
that the blade properly makes contact with the media.
Selecting "2mm BELOW" will change the Initial Blade Control Position to 2 mm below the cutting start point (2 mm
from the edge of the point from which the media will be shifted.)
Selecting "Y OUTSIDE" will initialize Initial Blade Direction Setting outside the cutting area.
Selecting "SPECIFIED Y POSITION" will initialize Initial Blade Direction Setting at the Y direction xed position
that has been set.
* When media narrower than the set Y position is set, it will be the Y maximum value.
Feed direction of media
Feed direction of media
2mm
Push roller
Initial Blade Control Position
Setting Point (Set as
"OUTSIDE")
Cut Start Point (Cutting Origin
Point)
Initial Blade Control Position Setting
Point (Set as "2mm BELOW")
Cutting area
CAUTION
Selecting [Y OUTSIDE] and then changing the expand setting to a positive digit (8 mm ABOVE) can damage the cutting mat.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
To Next Page
Loading...
