1-5
Media stopper ......................... This stops the stock shaft from spinning when setting in media. It is utilized
when pulling roll media straight out.
Pen station/Pen holder .......... A second pen is set.
Media ange ...........................Fixes the paper roll (media) in place as per settings.
Media guide ............................Guides the paper (media) during the plotting/cutting process.
Stock shaft ..............................A shaft that takes in roll media.
Rear view
AC line inlet
Basket
Push roller hold-down force
switching lever
Media guide bar
Stand
Network (LAN) interface
connector
USB interface
connector
RS-232C interface
connector
USB memory dedicated
connector
Media sensors
AC line inlet ............................. Inlet where the power cable is connected.
Push roller hold-down force switching lever
.........................Switches the hold-down force of the push roller to 3 stages of strong, medium
and weak.
USB interface connector .......Used to connect the plotter to the computer with a USB interface cable.
RS-232C interface connector
.........................Used to connect the plotter to the computer with a RS-232C interface cable.
(It is available as an option depending on the region. For details, please contact
your dealer.)
Network (LAN) Interface connector
.........................Used to connect this plotter with a network (LAN) I/F.
USB memory dedicated connector
................................................USB memory dedicated connector.
Stand .......................................A stand to put the machine on.
Basket ......................................The container for receiving the media.
Media guide bar ......................Shaft that used to set the roll media.
To Next Page
Loading...
