GRAPHTEC CE7000-130AP - Cross cut the roll paper

7-25
7. 9
Cross cut the roll paper
The operation to separate media is called "Cross Cut".
You can manually cross-cut at any position or cross-cut automatically at the end of cutting.
The blade force to cross-cut is called Cross Cut force and can be adjusted.
CAUTION
Do not place your hands where the blades pass. There is a danger of injury.
Supplement
•
Cross Cut is available only when using roll media. Sheet media cannot be cross-cut.
•
Clean the cutting groove regularly with a cotton bud or the like. If the dust or the like accumulates, the cutter cannot operate properly.
•
If cross-cut media is placed on the media sensor, remove the cross-cut media. If it is not removed, it is judged as a cut failure and
Cross Cut operation is performed again.
•
Set "Push roller sensor setting" and "Media sensor setting" to Enabled. If it is set to Disabled, Cross Cut operation is not available.