GRAPHTEC CE7000-130AP - Setting Step Size (GP-GL STEP SIZE)

11- 4
Related to GP-GL command
This section is useful only when using the GP-GL command.
Setting the step size (GP-GL STEP SIZE)
The distance to travel with 1 step can be changed. Match the setting value of the application to be used.
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (2/4) is displayed.
4
Press the [1] key (GP-GL STEP SIZE).
GP-GL STEP SIZE screen is displayed.
5
Press the [1] key (0.100 mm), the [2] key (0.050 mm), the [3]
key (0.025 mm), or the [4] key (0.010 mm).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to INTERFACE screen (2/4) .
7
Press the [PAUSE/MENU] key.
It will return to default screen.