GRAPHTEC CE7000-130AP - Setting a Time Out

6-3
6.2
Setting a Time Out
Regarding the timeout settings, when the data input time to the interface becomes equal to or longer than the
specied time, that point in time is regarded as a data break. All data up to the data break will be plotted, after it,
cross cut will be performed.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (4/4) is displayed.
4
Press the [1] key (TIME OUT).
TIME OUT screen is displayed.