3-13
Stop cutting
Operation
1
Press the [PAUSE/MENU] key.
Operation will stop and following screen is displayed.
Supplement
It will resume cutting by pressing [1] (CONTINUE
JOB) key.
See "Pause and Resume Cutting".
2
Press the [2] key (QUIT JOB).
Following screen is displayed.
Supplement
•
It will return to operation stop screen without
clearing buffer memory when [ESC] key
(CANCEL) is pressed.
•
In the case that the operation is interrupted
and the buffer is cleared, make sure that the
data transfer is stopped.
If the data transfer continues, abnormal
operations where data is processed from the
middle may occur.
3
Conrm if the data transfer from the computer is stopped and
press the [1] key (YES, CLEAR).
Following screen is displayed, the buffer memory is cleared, and it will
return to default screen.
To Next Page
Loading...
