A-14
A.5
Initial Setting
Menu items Setting item Initial value
TOOLS SETTING
(TOOL)
TOOL OFFSET ADJ. –
STEP PASS 1
OFFSET FORCE –
OFFSET ANGLE 30
DATA SORTING ON
CONDITION PRIORITY PROGRAM
TOOL UP MOVE
DISABLED
MOVING SPEED AUTO
TOOL UP HEIGHT NORMAL POSITION
BLADE WEAR ALARM SETUP OFF
INITIAL B. ANGLE POSITION 2mm BELOW
AXIS SETTING
(AXIS)
AXIS SETTING
OFF
AREA PARAMETERS
(AREA)
AREA SET LOWER LEFT (DEFAULT)
AREA SET UPPER RIGHT (DEFAU LT )
EXPAND (DEFAU LT )
ROTATE OFF
MEDIA SETTING
(MEDIA)
'F'COMMAND CUT OFF
AUTO PRE FEED OFF
AUTO PRE FEED FEED LENGTH 1m
PAGE LENGTH 300.0cm
INITIAL FEED OFF
FEED SPEED NORMAL POSITION
CROSS CUT FORCE 20
PANEL CUTTING OFF
DIVIDE LENGTH 100.0cm
CROSS CUT ON
SPACE REAR 70mm
PAPER LOAD FUNCTION 2
PAPER READY TIME 180sec
INTERFACE
(I/F)
COMMAND HP-GL
HP-GL ORIGIN POINT LOWER LEFT
HP-GL MODEL EMULATED 7586
GP-GL STEP SIZE 0.100mm
RS-232C (SWITCHING SETTING NUMBERS) No.1
RS232C: FORWARDING CONDITION
BAUD RATE /DATA BIT/
PARITY/HARDWIRE HANDSHAKE
RS-232C No.1 : 9600/8/NONE//HARD
RS-232C No.2 : 9600/7/EVEN//HARD
RS-232C No.3 : 9600/8/EVEN/XonXoff
RS-232C No.4 : 9600/8/EVEN/XonXoff
LAN DHCP OFF
LAN IP 192.168.0.1
LAN SUBNET MASK 255.255.255.0
LAN GATEWAY 192.168.0.254
COMMAND ':',';' ENABLED
COMMAND 'W' TOOL UP
CIRCLE RESOLUTION DEFAULT
ADVANCE
(ADV.)
MOVE STEP 0.1mm
LANGUAGE SELECTION Select when initially turning on power
LENGTH UNIT Select when initially turning on power
BEEP FOR KEY OPE. ON
POSI. KEY SPEED + SLOW KEY 1cm/s
POSI. KEY SPEED 10cm/s
PAUSE/MENU KEY SETTING PAUSE
LCD CONTRAST 0
MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
FAN POWER NORMAL POSITION
TEST
(TEST)
NO SETTINGS –
To Next Page
Loading...
