GRAPHTEC CE7000-130AP - When Feeding Long Media (2 Meters or More)

2-12
7
Position the media and the push rollers to correspond with
the width of the media.
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers" for the
position of the push rollers.
•
See "Aligning the Push Rollers" for information
about push roller hold-down force.
Use the 5 push rollers to push down the sides and center of
the media. Use the grit roller position guide and make sure
the push rollers are on top of the grit rollers.
Use the grit roller position guide to make sure the push
rollers are set on top of the grit rollers.
You can adjust the push roller's hold-down force.
Grit roller position guide
Push roller
Media sensor
Grit roller
Push roller
(The center push roller is not on top of the grit roller.) (The center push roller is near the edge.)
(The center push roller is on top of the grit roller.)(The center push roller is on top of the grit roller.)
When feeding long media (2 meters or more)
Position the push rollers at least 15 mm inside the edges of
the media.
Push roller
Media
15 mm 15 mm