GRAPHTEC CE7000-130AP - Setting the Command (GP-GL;HP-GL)

11-2
Related to command processing
Setting the command (COMMAND)
There are 2 types of commands, the GP-GL and the HP-GL, that the plotter can use.
Match the setting value to the used software.
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the [2] key (COMMAND).
COMMAND screen is displayed.
4
Press the [1] key (GP-GL) or the [2] key (HP-GL).
5
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to INTERFACE screen (1/4).
6
Press the [PAUSE/MENU] key.
It will return to default screen.