GRAPHTEC CE7000-130AP - Setting the Tool; Setting Condition No.1 (Pen Plunger Specific)

2-36
Setting the tool
Set the type and offset value of the tool that is used in each of the tool condition numbers.
Condition No.1 applies specically to use of the pen plunger for the either oil-based ballpoint pen or water based
ber-tip pen.
Condition No.2 to No.8 applies specically to the use of the cutter plunger.
Setting Condition No.1 (Pen plunger specic)
Operation
Supplement
Please select Condition No.1 under "Selecting
the Tool Conditions" when setting up tool
conditions for the pen plunger, and choose
"Condition No.2" to "Condition No.8" when
setting up the tool conditions for the cutter
plunger. For more information, see "Selecting
Tool Condition".
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
Press the [1] key to change the CONDITION No.
It will return to CONDITION setting screen
without changing the settings when you press
the [ESC] key (CANCEL).
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
Supplement
Please note that Condition No.1 is pen plunger
specic, and does not alter other tool settings.
3
Conrm that "PEN" is set and press the [ESC] key (CANCEL).
It will return to TOOL setting screen.
4
Press the [COND/TEST] key.
It will return to default screen.