2-20
Changing the hold-down force
The CE7000-130AP requires the push roller hold-down force to be set based on the media's width and material
type in order to keep the media in place.
Switching
(1) Raise the media set lever to lower the push rollers.
(2) Use the push roller hold-down force switching lever on the back of the push roller to adjust the center push
roller's hold-down force. It can be set to Strong, Medium or Low (OFF).
(3) When the push roller hold-down force switching lever is lower, it is in Strong mode. When it is upper it's in
Low (OFF) mode.
Hold-down force: Low (OFF) Hold-down force: Medium Hold-down force: Strong
Lever Lever Lever
CAUTION
•
Please switch the hold-down force of the push rollers at both ends to Strong or Medium and keep the same hold-down force.
•
If the hold-down force is changed with the media set lever lowered, the lever operation will be heavier. Always raise the media set
lever and then change itch the hold-down force.
Supplement
•
Low (OFF) of hold-down force is the standard setting for cutting thin lm like car lm.
•
Switch the hold-down force as necessary for different types of media.
To Next Page
Loading...
