4-7
Setting the number of pre feeds
Set the number of pre feeds to prevent deviations from occurring when the roll media is pulled out. During the
pre feed, the grit roller leaves traces on the paper. Pre feeds can be repeated after paper exposure time has
elapsed.
This function is available when the Initial Feed or if Partition Pastern is ON.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the POSITION ( ) key.
MEDIA SETTING screen (3/3) is displayed.
4
Press [3] key (PAPER LOAD FUNCTION).
PAPER LOAD FUNCTION setting screen is displayed.
Supplement
•
You can set between 0 and 5.
•
Cutting/plotting will begin immediately after
the pre feed is complete and data sent during
paper exposure time is received.
5
Press the POSITION ( ) keys to change the current setting.
To Next Page
Loading...
