GRAPHTEC CE7000-130AP - Setting a Separator (GP-GL & HP-GL)

6-5
6.3
Setting a Separator
Regarding the separator settings, the command that is set as separator is judged as the data break when it is
sent. All data up to the data break will be plotted, after it, cross cut will be performed.
GP-GL separator
Set the separator at GP-GL.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (4/4) is displayed.
4
Press the [2] key (GP-GL SEPARATOR).
GP-GL SEPARATOR screen is displayed.