GRAPHTEC CE7000-130AP - RS-232 C Interface

9-3
RS-232C interface
When using the RS-232C interface*, set the command settings, step size settings (when using GP-GL
commands), origin point settings for HP-GL (when using HP-GL commands), and transfer conditions for the RS-
232C interface. The transfer conditions for the RS-232C interface can be set from the operations panel. The
transfer condition should be set to the same in the software used and in the CE7000-130AP. If there is a mistake
in the settings an error may displayed in the plotter and lack of data can cause a malfunction. In such a case,
please conrm the data transfer settings again.
* RS-232C interface is optional depending on region. For details, please contact the distributor where you
purchased.
(See "Setting Origin Point When HPGL is Set")
(See “Setting the STEP SIZE”)
(See "Setting the Command (COMMAND)")
(See "Connecting with RS-232C")