GRAPHTEC CE7000-130AP - HP-GL Separator

6-6
Supplement
You can set to "FS", "H", "J 0", "F" or "-".
When set to "-", cross cut by separator is not
performed.
5
Press the POSITION ( ) keys to change the setting.
Supplement
It will return to INTERFACE screen (4/4) without
changing the settings when you press the [ESC]
key (CANCEL).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to INTERFACE screen (4/4).
7
Press the [PAUSE/MENU] key.
It will return to default screen.
HP-GL separator
Set the separator at HP-GL.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (4/4) is displayed.