4-16
4.3
Panel Cutting
To prevent skew of long media, utilize Panel Cutting when cutting.
Supplement
•
When Panel Cutting is on, the machine will begin by dividing up partition length and continue cutting until one of the following data
breaks appears. When the rst partitioned area cut is nished, the machine will move to the next area, and repeat this until all areas
have been cut.
•
Data Breaks:
(1) No data sent for a few second after nishing cutting. (Time Out)
(2) A feed-related command is set. (GP-GL: F, FS commands, HP-GL: AF, AH, PG commands)
(3) HP-GL: SP0, NR, GP-GL: J0, SO.
(4) When commands from data breaks (2) and (3) appear, that command work will begin after the Panel Cutting is nished.
•
Panel Cutting will continue for each piece of data when a data break is caused by a command, even if multiple pieces of data are
sent in before the cutting nishes (even when numerous pieces of Panel Cutting data are in the plotter buffer).
•
When Panel Cutting and auto media transfer are both turned on, the machine will ignore automatic media transfer length settings
and continue working with priority of partition length plus something minutes ago (with footprints).
•
When Panel Cutting is set to ON, copy, initial feed, and cutting area cannot set.
•
Panel Cutting cannot be done when one le of data makes the buffer full. Make sure to always send in data lower than the buffer
size.
•
When Panel Cutting is on, set the cutting/plotting speed to 30 cm/s.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
To Next Page
Loading...
