GRAPHTEC CE7000-130AP - User Selection Settings

9-14
9.5
User selection settings
Call up the user selection settings (CAD). "Command", "Origin point", "Step size", "Separator", "Timeout", "Page
length", and "Transfer conditions for RS-232C" have been set.
Setting user selection
Call up the user selection settings (CAD). "Command", "Origin point", "Step size", "Separator", "Timeout", "Page
length", and "Transfer conditions for RS-232C" have been set.
List of user selection settings
User selection settings 1 2 3 4 5 6 7 8
Command HP-GL HP-GL GP-GL HP-GL HP-GL HP-GL HP-GL HP-GL
Step size 0.025 0.025 0.025 0.025 0.025 0.025 0.025 0.025
Origin point LOWER
LEFT
CENTER LOWER
LEFT
LOWER
LEFT
LOWER
LEFT
CENTER CENTER CENTER
Separator PG NR J0 SP PG SP None None
Time out 0 0 120 120 1 10 0 0
Page length (mm) 1500 3000 1500 5000 3000 1500 5000 5000
Transfer conditions 9600N81X 9600N81X 9600N81X 9600N81X 9600N81X
19200N81X 9600N81X 9600N81X
Step pass – – – – – 0 – –
Moving speed – – – – – 60 cm/s – –
Cross cut – – – – – ON – –
Cut line pattern – – – – – OFF – –
Space rear – – – – – 12 mm – –
–: The current value is set.
User preference 6 is determined as per the following cutter pen conditions (all settings other than those listed
revert to default).
The settings other than the table are set to default value.
Condition No. Speed Acceleration Force Pen type
(Cutter blade)
Compensation value
(Offset)
1 60 1 17 Pen –
2 30 1 14 09U 0
3 30 1 14 09U 0
4 30 1 14 09U 0
5 30 1 14 09U 0
6 30 1 14 09U 0
7 30 1 14 09U 0
8 60 1 14 09U 0