2-23
2.6
Connecting to the Power
Turning on the power of the plotter.
Operation
1
Check that the power switch is turned off. (the " " side is
pressed down)
2
Connect one end of the provided power cord to the CE7000-
130AP AC line inlet and the other end to an electrical socket
of the rated supply voltage.
Supplement
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
3
Turn on the CE7000-130AP by pressing the "|" side of the
switch. LCD on the control panel is lit.
Supplement
•
The Default Screen will appear after
purchasing the machine. See "About the
Default Screen" for more information.
•
This screen is described as "default screen"
in this document.
•
Settings such as initial media feed speed and
communication conditions can be performed.
4
If media has not been loaded, the rmware version number is
displayed, followed by a prompt to load media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
To Next Page
Loading...
