7-15
7. 5
Setting Cut Line Pattern
Lines can be cut with perforated lines so the cut parts will not fall off. There are 8 different patterns of perforated
lines set as 0 to 7, and the ratio of cut and uncut part differs in each (tool is raised or the force is decreased for
following length every 8 mm of the cut). The uncut part becomes shorter with smaller value, making it easier to
separate the cut parts.
In addition to 8 patterns, "OFF" which cuts by the solid line without perforation patter and "USER" where user can
specify a unique pattern are provided.
The processing in the part is not cut with perforation patter is adjusted in "UP MODE".
The perforation patter can be set for each condition number.
Supplement
•
Use the Tool Holder (forward).
•
Use Tool Holder (forward) when cutting with any perforation pattern (aside from turning it off).
Flange
Bracket to hold tool
This cutter holder is not set
backward.
Tool holder
(Forward)
Tool holder
Seen from above
•
Replacing a damaged cutting mat will require a service fee.
•
When using the FORCE setting command to control the perforation pattern, set to "OFF".
Guideline to perforation pattern
Thickness of material Pattern number Cutting length (L) Up length (L)
Approx. 130g/m
2
3 30.00 mm 1.00 mm
Approx. 80g/m
2
5 30.00 mm 1.40 mm
Approx. 65g/m
2
1 15.00 mm 1.40 mm
* The materials of 60g/m
2
or less are not suitable for cut with perforation pattern. We recommended that they are
used for a pen plotting.
To Next Page
Loading...
