GRAPHTEC CE7000-130AP - Connecting the Plotter to a Computer

1-7
1.4
Connecting to the Computer
Connect the plotter to the computer using the interface cable. Use one of the USB ports, the network (LAN)
interface or the RS-232C port to connect the plotter to the computer. Select the port depending on the specication
of the software to be used and the availability of the interface port on the computer.
Please install driver software before connecting.
Depending on the port used, use one of the USB cable (standard accessories), the network (LAN) cable
(commercially available product) or the RS-232C cable (commercially available product) to connect. Use the
cables specied by Graphtec, matching the computer that is to be connected.
* RS-232C interface is available as an option depending on the region. For details, please contact your dealer.
Connection
1
Check that the power switch is turned off (the " " side is
pressed down).
Supplement
See the "Setting Interface" for setting the
interface.
2
Connect the plotter to the computer using the interface cable.
Connection via USB interface
USB cable
(accessories)
Computer