2-8
2.3
Loading Media (Paper)
Both roll media and sheet media can be used with the CE7000-130AP. Load the media according to the
instructions given for each type.
Use the grit roller on the right side of the media (looking from the front) as a guide when setting it in the media
sensor. Afterwards, adjust the push roller so that it's lined up with the side of the media.
•
Loading Roll Media
•
Loading Sheet Media
CAUTION
Notes when using roll media
•
If the media is not put in the basket and there are problems in the media feed, reduce the media feed speed.
•
Take all cut/plotted paper out of the basket; paper left in the basket may cause deviations and affect performance for subsequent
jobs.
Loading roll media
Operation
1
Set the media ange and paper to the stock shaft and insert
in the direction of the paper.
Stock shaft
Flange screw
Media ange
Media ange
Supplement
When installing, place the paper roll as follows:
To Next Page
