2-7
Attaching a pen
Attach a pen to the pen station.
•
Please make sure to attach the pen to the pen station when setting up a pen.
•
To prevent injury, avoid touching the pen immediately after the cutting plotter is turned on or whenever the pen
is moving.
Operation
1
You can attach the pen by opening up the holder on the pen
station with your nger.
Holder
Supplement
Make sure to check that the top part of any tools
mounted on the pen station is set in the grooves
above the pen.
2
Once the pen is attached, releasing the holder xes the pen
in place.
Always t into grooves on the pen.
Removing a pen
You can remove the pen by lifting up the holder.
To Next Page
Loading...
