2-5
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or
whenever the tool is moving.
The tool holder is suitable only for use with the cutter plunger. Please refrain from attaching the plotting pen to it.
Tool holderBracket to hold tool
Top
Tool holder (Forward)
This tool holder is not set backward.
CAUTION
When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
Supplement
•
SupplementPlease make certain to set the cutter plunger of the tool holder (forward).
Mounting
1
Loosen the tool holder screw.
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top
To Next Page
Loading...
