2-11
5
Lower the media set lever to raise the push rollers.
Push rollers
Media set lever
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers" about the
position of the push rollers.
6
Put the roll media on the roll media tray and then push the tip
of the roll media forward from the back of the machine. Make
sure to pull it so that there is no slackening across the roll
media's route.
Media guide bar
Media sensor
The paper roll media's route goes over the center bar and
behind the media guide bar.
Media guide barCenter bar
To Next Page
Loading...
